Milk Truck back next

Built by: Mike Sharpless in Philadelphia, PA

I started this build with a glue bomb I picked up off eBay. Some of the parts were so glued up that I could not save them. So I went into my parts box and found a steering wheel, a column, radius rods, a drag link, front and rear springs, and a set of headlights. The 3D printed header pipes I picked up from eBay.

The rims were scratch-built using chrome rings glued on top of smaller rims to make them a deep dish rim. I wanted a show-car-looking tire, so I used a set from a Formula One car kit.

I flocked the interior pink and purple to match the exterior paint. The decals came from the milk trike kit, and most of the chrome.

was redone with Revell chrome spray. The body was airbrushed with a custom mix of decanted Tamiya spray and top-coated with Testors wet look clear.

Thanks for lookin'!

NOTE: Click on the images to supersize them, then use the back arrow on your browser to return here.